Three layer/ level roll forming machine for roofing / corrugated panel, rollforming
Brief Introduction:
The three layers of roll forming parts on this three layer roll forming machine cannot work at the same time, which means left two of the roll forming systems (top roll forming and middle and bottom roll forming) will stop when the other is working.
A three layer roll forming machine has three layers or three levels of roll forming parts. When the rent rate is more and more expensive in the modern days, still many person consider three similar roofing/wall cladding profile in one machine for below two functions
- Share the un-coiler and motor and PLC control system and hydraulic group together, can save the cost
- To save the space of the factory
While if any layer profile has problems, and when you want to check, it is not so convenient, so it is the main issue for daily maintaining.
Quick Detail:
- Thickness : 0.4-0.8mm
- Material : G550/G350, pre-painted sheets
- Input width : 914/1000/1219/1250mm
- Coil ID: 508mm
- Effective width:760/820/1000+/-4mm
- Material weight: 5Tons cap.
- Driven motor: 11Kw motor with gear box normally
- Cutter Material: Cr12, heat treatment
Machine list:
- Hydraulic De-coiler
- Dual layer roll former
- Two sets of hydraulic cutting device
- Run out table or automatic stacking device
- Siemens PLC and IOP/ touch screen, Schneider brand inverter
Description/Technical Parameter details of complete line:
- 5TX1250mm Hydraulic Un-Coiler with coil car
Hydraulic system to expand coil inner hole, Pump motor: 3KW
Coil Inner-diameter= 510±30mm
Load Capacity: Max. 5 Tons, Coil Width Max. 1250mm
Taper wedge expand type
Driving motor to turn the coil, 3KW, manual frequency speed control
Other design such as snubber arm /support arm/coil car as per request
- Entry Roller & Manual Pre-shearing device
Two sets of pre-shearing device
to cut off the end of the final piece of sheet only
Working thickness: max. 0.8mm
- Roll forming machine with cutting details as below table :
| Suitable roll forming material | Color steel sheet or galvanized steel sheet |
| Thickness | 0.4mm-0.8mm |
| Coil input width | 914/1000/1219/1250mm |
| Carriage Frame design | Wall-plate-frame-design, dual layer |
| Roll forming stages | 16/18, 18/18, 20/20 stages for example |
| Material of roller | 45# steel, CNC lathes, Hard Chrome Coated Option : with roller heat treatment |
| Shafts Diameter | Φ75mm |
| Main motor power | 5.5Kw with reducer |
| Roll forming speed | 15-20m/min (Higher speed is available, depends on the specification required by the buyer) |
| Hydraulic group power | 4.0 Kw or 5.5Kw |
| Material of cutter | Cr12, hear treatment/Cr12Mov, heat treatment |
| Electric Voltage Standard | 380V/50Hz/3PH or as requirements |
| Major Color of Machine | RAL 5015(Blue) or as requirements |
Siemens brand PLC and touch screen, Schneider/ Shihlin/ Delta brand Inverter, Omron encoder
Cut-to-length tolerance≤±1mm
Control Voltage 24V
- Product Rack Un-powered, 3 units
Profile Drawing/Layout/Equipment reference pictures:
Product Tags:
|
|
Three Layer / Level Corrugated Steel Panel Roll Forming Machine For Roofing Images
|
